circuitwiringdiagram.com

To replace a taillamp, turn signal lamp, stop lamp, or back-up bulb of Chevrolet Aveo 2009, this procedure should be followed :

2009 chevrolet aveo hatchback taillamp replacement guide

2009 chevrolet aveo sedan taillamp replacement guide

1. Open the liftgate or trunk.
2. Remove the two screws and the lamp assembly.
3. Turn the bulb socket counterclockwise and remove the socket.
4. Press the bulb in and turn counterclockwise to install the bulb in the socket.
5. Press the new bulb in and turn clockwise to install the bulb into the socket.
6. Turn the bulb socket clockwise to reinstall.
7. Reinstall the lamp assembly and two screws.

Posts Related to 2009 Chevrolet Aveo Taillamps, Turn Signal, Sidemarker, Stoplamps, Back-up Lamps Replacement Guide

2009 Chevrolet Aveo Headlamp Bulb Replacement Guide

For the proper type of replacement bulb of Chevrolet Aveo 2009, this procedure should be followed : 1. Open the hood. 2. Remove the three ...

2010 Ford Focus Light Bulb Replacement

Lamp assembly condensation Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air ...

2009 Chevrolet Aveo Engine Compartment Fuse Block Diagram

The engine compartment fuse block of Chevy Aveo 2009 is located on the driver side of the vehicle near the battery. Spilling liquid on any ...

1975-1991 Jaguar XJ-S Interior Lights and Bulb Failure Schematic

Interior lights and bulb failure electrical connection and wiring diagram of Jaguar XJ-S is shown in the figure below. Different models are cabled differently and ...

Tags: replacement guide

This entry was posted on Monday, May 10th, 2010 at 11:19 am and is filed under car automobiles, chevrolet. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.